tubi in carbonio, discussioni da chi non è totalmente disinteressato.
Inviato: 17/11/2009, 23:15
It was brought to our attention an interesting discussion and we outline some excerpts for our readers. All posts are property of respective owners for any intellectual rights there may be associated, and are excerpted here with the purpose of discussion, critique, and learning.
----------------------------------------------------------------------------------------------------
Rolando and others,
Can you explain why carbon fiber tubes may exacerbate tube currents in Mak and Cass scopes? It is my understanding that carbon fiber cools faster than aluminum and that it can get to a lower temperature than the outside air very quickly. I would think this would be a good thing when heat emmited from aluminum that is used for baffles, mirror cells etc.. is trapped inside the tube and rises to the top of the tube. Does carbon fiber act as an insulator so that the carbon fiber in contact with the outside air is a different temperature than the interior carbon fiber and little of the interior heat is transferred to the outside? [...]
Lots of folks also use cork to line the interiors of their tubes for insulation. I can't help thinking that this could also be deleterious.
Sincerely,
Tom Mack
Eh no caro collega, questa è la classica frittata rigirata da chi non vuole assolutamente cambiare la propria tecnologia interna. Al di la delle proprietà della fibra in carbonio o dell'alluminio (e qui dovremmo discutere di come si è fatto il tubo in carbonio e di come si è fatto quello in alluminio), possiamo dire - con cognizione di causa - che quando affermato non corrisponde al vero. Il primo punto è usare masse vetrose limitate (dove possibile), il secondo punto è di creare celle di supporto molto ben disegnate con poca massa e con il controllo accurato dei flussi, il terzo ed ultimo punto è applicare la fibra nel modo opportuno.
Il problema delle termiche è - secondario se ben gestito - rispetto a quello presentato dalle variazioni dimensionali con strumenti metallici.
Naturalmente se non gestisci bene la fibra......allora tutto si somma.
Maxproject
0
----------------------------------------------------------------------------------------------------
Rolando and others,
Can you explain why carbon fiber tubes may exacerbate tube currents in Mak and Cass scopes? It is my understanding that carbon fiber cools faster than aluminum and that it can get to a lower temperature than the outside air very quickly. I would think this would be a good thing when heat emmited from aluminum that is used for baffles, mirror cells etc.. is trapped inside the tube and rises to the top of the tube. Does carbon fiber act as an insulator so that the carbon fiber in contact with the outside air is a different temperature than the interior carbon fiber and little of the interior heat is transferred to the outside? [...]
Lots of folks also use cork to line the interiors of their tubes for insulation. I can't help thinking that this could also be deleterious.
Sincerely,
Tom Mack
Eh no caro collega, questa è la classica frittata rigirata da chi non vuole assolutamente cambiare la propria tecnologia interna. Al di la delle proprietà della fibra in carbonio o dell'alluminio (e qui dovremmo discutere di come si è fatto il tubo in carbonio e di come si è fatto quello in alluminio), possiamo dire - con cognizione di causa - che quando affermato non corrisponde al vero. Il primo punto è usare masse vetrose limitate (dove possibile), il secondo punto è di creare celle di supporto molto ben disegnate con poca massa e con il controllo accurato dei flussi, il terzo ed ultimo punto è applicare la fibra nel modo opportuno.
Il problema delle termiche è - secondario se ben gestito - rispetto a quello presentato dalle variazioni dimensionali con strumenti metallici.
Naturalmente se non gestisci bene la fibra......allora tutto si somma.
Maxproject
0